GPS and temperature monitoring for refrigerated transport
Cold chain.
Fully documented.
See where the van is and how warm it is in the load space. After the run you get a report covering the whole route and every breach of your threshold.
The sensor in the load space sends its reading to the tracker, and the tracker passes it to Trackomo in the same packet as the coordinates, the speed and the ignition state. Readings stay in the system for a year, so six months later you can still pull up a single run.
One run, minute by minute
From the loading bay to the chiller cabinet
Goods down to −19.8 °C
The sensor confirms the temperature before the van leaves the bay. First reading on the road at 07:01, the next one half a minute later.
Position and temperature on one screen
The map shows the van, its speed and the temperature in the load space. Your customer can get a link with the position and the arrival time, without signing up.
Temperature rose for seven minutes and came back
The rise to −14.2 °C goes into the report with its duration and its place on the map. No alert was sent, because the threshold was set to ten minutes above −15 °C.
An example of one day. Sample data.
Alerts
The alert arrives when the fridge unit stops holding
You set a threshold and the minimum time it has to be exceeded. A short rise while unloading triggers nothing; twelve minutes above −15 °C does.
HACCP reports
The HACCP report lands in your inbox the next morning
Every run and every reading. A PDF with the chart and the measurement table – the same file you show an inspector and send to the customer who took the goods.
Vehicle data
Transparent data
The FMC003 plugs into the OBD socket. On supported models it reads the odometer, the fuel level, the battery voltage and fault codes.
Sample data.
Who uses it
Simple pricing
No bundles and no paid modules. The first 30 days are free.
Prices exclude VAT. Discounts from ten vehicles and the partner offer – see pricing.