Features
What the GPS and temperature monitoring app does
One app for vehicles, refrigerated vans and the cold room at the back of a shop. The plan decides the limits, not which screens you get to see.
Live map
Every vehicle on one map, with its heading and the time of the last signal. It refreshes every few seconds.
Temperature on the road
Up to four sensors per vehicle. A chart across the whole run, a threshold and the minimum time it has to be exceeded, so a delivery does not set off an alert.
HACCP reports
A PDF for a whole day or a single run: chart, measurement table and the list of threshold breaches. Sent to the addresses you choose, at the time you choose.
Alerts
Temperature above threshold, geofence entry and exit, speed, loss of sensor signal, low battery voltage.
Vehicle data
Odometer, fuel level, battery voltage and fault codes from the OBD socket. How much of it you get depends on the model.
History and replay
Trips and stops with addresses. You replay a route point by point, with the temperature chart from the same run beside it.
Mileage logs
Business and private trips kept apart, a rate per kilometre and a mileage record ready to export as CSV.
Panel and API
The panel runs in a phone browser, installs like an app and sends push notifications. There is a REST API for integrations.
How it works
Up and running in an afternoon
Plug in the tracker
The FMC003 goes into the OBD socket, usually under the steering wheel. No workshop, no wiring.
Fit the sensor
You stick the temperature sensor inside the load space, ideally at its warmest point, and pair it in the panel using the number on the case.
Set thresholds and report recipients
You enter a threshold for the sensor and the minimum time it has to be exceeded, then choose who gets the report and when.
HACCP reports
A report for every run, ready to hand to an inspector
- Readings from the whole run with their GPS position, not just at loading and unloading
- Threshold breaches with their duration and the place on the map
- The duration of every breach and where on the route it happened
- Blue PUCK T EN12830 sensor – the manufacturer declares conformity with EN 12830:2018 and supplies an EN 13486 calibration certificate on request
- Readings kept for a year, the period Regulation (EC) No 37/2005 asks for
Hardware
Teltonika trackers and ELA sensors
GPS tracker for the OBD socket
Plugs into the diagnostic socket. On supported vehicles it reads the odometer and the fuel level. Minimum firmware for the full data set: 03.28.03.Rev.94.
Wired GPS tracker
Inputs for wired probes and ignition cut-off. For reefers with a fridge unit and for bodies with no OBD socket.
Bluetooth temperature sensor
Range −40 to +85 °C, resolution 0.0625 °C, IP68 case. Lithium battery that lasts years, and no wiring in the load space.
Hardware priced on request
Try it on your own vehicles
You set the account up yourself, without talking to us. The first 30 days cost nothing.